Trace:

# Differences

This shows you the differences between two versions of the page.

Both sides previous revision Previous revision | Next revision Both sides next revision | ||

adps_with_symmetry_constraints [2018/03/06 02:47] rowlesmr3 |
adps_with_symmetry_constraints [2018/03/06 06:09] rowlesmr3 |
||
---|---|---|---|

Line 2: | Line 2: | ||

Description: Include symmetry constraints with anisotropic displacement parameters | Description: Include symmetry constraints with anisotropic displacement parameters | ||

- | Comment: by default, Topas (at least in v5-7), doesn't constrain the values of anisotropic displacement parameters according to the site symmetry. Symmetry constraints were taken from [1], which is a reprint of [2]. | + | Comment: In a particular version of Topas 5, it doesn't constrain the values of anisotropic displacement parameters according to the site symmetry. Symmetry constraints were taken from [1], which is a reprint of [2]. |

The macros below correspond to Table 4.1 in [1], which refers to Table 4.2, which gives the necessary restrictions for each Wyckoff site in each spacegroup. I'm assuming that a general position in any space group has no constraints on the ADP values. | The macros below correspond to Table 4.1 in [1], which refers to Table 4.2, which gives the necessary restrictions for each Wyckoff site in each spacegroup. I'm assuming that a general position in any space group has no constraints on the ADP values. |