Trace:

# Differences

This shows you the differences between two versions of the page.

Both sides previous revision Previous revision | |||

adps_with_symmetry_constraints [2018/03/06 06:09] rowlesmr3 |
adps_with_symmetry_constraints [2018/03/06 06:51] rowlesmr3 |
||
---|---|---|---|

Line 3: | Line 3: | ||

Comment: In a particular version of Topas 5, it doesn't constrain the values of anisotropic displacement parameters according to the site symmetry. Symmetry constraints were taken from [1], which is a reprint of [2]. | Comment: In a particular version of Topas 5, it doesn't constrain the values of anisotropic displacement parameters according to the site symmetry. Symmetry constraints were taken from [1], which is a reprint of [2]. | ||

+ | |||

+ | In all other versions of Topas, use the keyword "adps" to get Topas to insert the correct, symmetry-constrained values. | ||

The macros below correspond to Table 4.1 in [1], which refers to Table 4.2, which gives the necessary restrictions for each Wyckoff site in each spacegroup. I'm assuming that a general position in any space group has no constraints on the ADP values. | The macros below correspond to Table 4.1 in [1], which refers to Table 4.2, which gives the necessary restrictions for each Wyckoff site in each spacegroup. I'm assuming that a general position in any space group has no constraints on the ADP values. |