controlling_number_of_cycles_in_continue_after_convergence
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
controlling_number_of_cycles_in_continue_after_convergence [2018/06/11 14:55] – created johnsoevans | controlling_number_of_cycles_in_continue_after_convergence [2022/11/03 15:08] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Controlling Refinements by Number of Cycles ====== | ||
+ | TOPAS normally controls refinements by the number of iters. | ||
+ | |||
+ | <code topas> | ||
+ | | ||
+ | iters 1000000 | ||
+ | prm dummy 1 val_on_continue = If(Cycle == 10, Get(iters) = 0, 0); | ||
+ | </ | ||
+ | | ||
+ | From Alan on the forum, June 2018. |